I hope in the future release there will be the option to change the font size. When there's too many chord in 1 bar it is so hard to read with the current default size even if the chart was set to "S" at the start of the piece.
🙏🙏
Printable View
I hope in the future release there will be the option to change the font size. When there's too many chord in 1 bar it is so hard to read with the current default size even if the chart was set to "S" at the start of the piece.
🙏🙏
Any smaller and chords wouldn’t be readable on small phone screens.
If you want to display 4 extended quality chords in a measure without overlapping you may have to increase the length of the bar. (Use 8 spaces instead of 4)
That will of course change the appearance of the chart.
Post the chart here that's giving you trouble.
:))BOB
The option of changing the font size would not deprive one of viewing on a phone as you could always choose a larger font then.
I’m trying
C#m7/G# Dmaj9/E E/F# | Bm
Attachment 603
I think the default font is easier to read than the handwriting font.
I also prefer - instead of m
If I were writing that bar, I’d use D Δ/E to keep the 9 from tangling up with the following chord and using the alternate chord field, I’d place D Δ9 above. (for reading) I’d also make the two adjacent chords small using S/N
S and N (Small/Normal chord-font size)
https://www.irealb.com/forums/showth...al-chord-font)
If there was enough available space in the page, I might consider making it an 8-space bar.
:))BOB
Tap the image for a better look